Table of Contents
Advertisement
•
WND on—Symmetric Window thresholds are active. The switch points are above and below 100 by the offset
percentage
1.3.2 Buttons
(-)(MODE)
•
Decrease gain: press and release (-)(MODE), then press and hold (-)(MODE) to rapidly decrease gain
•
Enter Setup mode: press and hold (-)(MODE) for longer than 2 seconds
•
Navigate the sensor menu: press (-)(MODE)
•
Change setting values: press and hold (-)(MODE) to decrease numeric values
(+)(TEACH)
•
Increase gain: press and release (+)(TEACH), then press and hold (+)(TEACH) to rapidly increase gain
•
Start the currently selected TEACH mode: press and hold (+)(TEACH) for longer than 2 seconds (Two-Point Static
TEACH is the default)
•
Navigate the sensor menu: press (+)(TEACH)
•
Change setting values: press and hold (+)(TEACH) to increase numeric values
(-)(MODE) and (+)(TEACH)
•
Select menu items in Setup mode: press (-)(MODE) and (+)(TEACH) simultaneously
•
Select and save a parameter and return to Run mode: press (-)(MODE) and (+)(TEACH) simultaneously for
longer than 2 seconds
When navigating the menu systems, the menu items loop.
1.4 Laser Description and Safety Information
For Safe Laser Use - Class 2 Lasers
CAUTION: Never stare directly into the sensor lens. Laser light can damage your eyes. Avoid
placing any mirror-like object in the beam. Never use a mirror as a retroreflective target.
Class 2 Lasers
Class 2 lasers are lasers that emit visible radiation in the wavelength range from 400 nm to 700 nm, where eye
protection is normally afforded by aversion responses, including the blink reflex. This reaction may be expected to
provide adequate protection under reasonably foreseeable conditions of operation, including the use of optical
instruments for intrabeam viewing.
Use the sensor buttons (-)(MODE) and (+)(TEACH) to program the sensor.
See
Sensor Programming
•
Do not stare at the laser.
•
Do not point the laser at a person's eye.
•
Mount open laser beam paths either above or below eye level, where practical.
•
Terminate the beam emitted by the laser product at the end of its useful path.
CAUTION: Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radiation
exposure. Do not attempt to disassemble this sensor for repair. A defective
unit must be returned to the manufacturer.
www.bannerengineering.com - Tel: 763.544.3164
on page 9 for programming instructions.
Q3X Laser Contrast Sensor
5
Advertisement
Table of Contents
