Table of Contents
Advertisement
3.7 Sensor Menu Map
Top Menu
Sub Menu
BOTH
Output Operation
BOTH
Teach Process Selection
Offset Percentage
BOTH
BOTH
Response Speed
BOTH
Output Timing Delays
BOTH
Delay Timer
Available when
set to "on"
Available when
set to "1Sh"
BOTH
Input Wire Function
Sensitivity
BOTH
Cut-off Output Operation
BOTH
BOTH
Display Read
Exit Setup
BOTH
BOTH
Reset to Factory Defaults
BOTH
sets
selection
Light Operate
(
default setting)
Dark Operate
Two-Point Static Teach
Dynamic Teach
Window Set
Light Set
Dark Set
(min, 10, 20, 30, 40, 50) - Window & Light Set options (20% is default for Light Set and Window)
(min, 25, 50, 100, 200) - Dark Set options ( 50% is default for Dark Set)
Pct menu present when teach is set to Window, Light, or Dark
set Response Speed to 250 microseconds
set Response Speed to 1 millisecond
set Response Speed to 5 milliseconds
Response Speed menu not present when Input Wire Function set to Master or Slave
off: no delays enabled
on: enable on and/or off delay (set value in Delay Timer menu)
1 Shot, fixed output pulse duration
LO = Single fixed duration, On pulse when moving into light state
DO = Single fixed duration, On pulse when moving into dark state
ms
to
sec range, set Delay Timer value (seconds have decimal)
Menu not present when
is set to "off"
("ond" and "ofd" default to 0, "dt1" defaults to 1 or 10 depending on response speed setting)
off: input is not active, ignore pulses
laser off when pulled low
laser on when pulled low
set: Remote Teach input
Master sync line for two sensor cross talk avoidance (response speed is 25 ms)
Slave sync line for two sensor cross talk avoidance (response speed is 25 ms)
standard sensitivity
high sensitivity
low sensitivity
Output follows LO/DO selection; sensor treats target in background as dark state
Output switches OFF when target is beyond background suppression distance
Output switches ON when target is beyond background suppression distance
CtO menu present on LD50 models only
display on
display on, inverted
display off (enters sleep mode after 60 seconds)
display off, inverted (enters sleep mode after 60 seconds)
end: exit setup
no: do not reset to factory defaults
yes: reset to factory defaults
Figure 12. Setup Mode Menu Map
www.bannerengineering.com - Tel: 763.544.3164
Q3X Laser Contrast Sensor
23
Advertisement
Table of Contents
