Function Text; Monitor Function Text; Multi-Function Input Settings; Multi-Function Output Settings - YASKAWA A1000 Manual

3 Application Selection
Function Group
P1
Function Group
U7
No.
Monitor Name
(Addr.
Digital Operator Display
Hex)
U7-02 Absolute Slave Frequency
(661h) Slv Abs Freq
U7-03 Ripple Slave Frequency
(662h) Slv Ripple Freq
U7-04 Base Slave Frequency
(663h) Slv Base Freq
Setting
80h
Setting
40h
41h
10
Table 5 Function Text
Disturbed Waveform Adjustment
Disturb WF Adj
Table 6 Monitor Function Text
Traverse Monitors
Traverse
Base frequency reference summed with the
anti-phase dither.
Anti-phase dither alone.
Base frequency reference (before disturbed
waveform is applied).
Table 8 Multi-function Input Settings (H1-
Disturbed WF Off
Open: Disturbed waveform enabled
Closed: Disturbed waveform disabled
Table 9 Multi-function Output Settings (H2-
Disturb UP Sts
Open: The disturbed waveform frequency is decreasing
Closed: The disturbed waveform frequency is increasing
During Disturb
Open: Disturbed waveform disabled
Closed: Disturbed waveform being generated
Function Name
Digital Operator Display
Monitor Name
Digital Operator Display
Table 7 Monitors
Description
Description
Description
YASKAWA TM.A1000SW.029 Traverse Application A1000 Custom Software Supplement
Analog Output
Unit
Scaling
10V: Maximum
Frequency 0.01 Hz
(E1-04)
10V: Maximum
Frequency 0.01 Hz
(E1-04)
10V: Maximum
Frequency 0.01 Hz
(E1-04)
)
)
Control Mode
Access Level
V/f V/f
OLV
OLV/PM
V/f V/f
OLV
OLV/PM
V/f V/f
OLV
OLV/PM
Control Mode
Access Level
V/f V/f
OLV
OLV/PM
Control Mode
Access Level
V/f V/f
OLV
OLV/PM
V/f V/f
OLV
OLV/PM