Web Access - Welch Allyn Spot VS100 Directions For Use Manual

Directions for use

Web Access

When connected to a wireless network, the vision screener gives you the ability to view
files from a web browser (Internet Explorer, Firefox, Safari, etc.) on a PC on the same
network.
To access the webserver on the vision screener:
1. From your computer, open a web browser; enter the devices IP address in the
address bar (this is located on the top black bar on the Home Screen).
2. You will be prompted to enter the username and password.
Username: spot
Password: 0000
0
Note
3. Default will go to the Report folder. This contains the pdf folder where you can find
subject PDF files.
4. To view the SpotResults.csv file change to the "db" directory.
Licensing
In order to use the screening functionality of the vision screener, the device needs to be
licensed. If your device came new from the factory with this instruction document, your
license is already installed and active. If you have updated the software on your device,
the licensing will need to be updated as follows:
1. Connect an empty USB device to the vision screener USB port.
2. Go to Tools, then press the License button.
3. After a moment, a dialog box will appear indicating that the registration file has been
exported to the USB drive.
4. Send the file titled spot-[serial number].reg to Welch Allyn Support at
customerservice@welchallyn.com.
Welch Allyn Support will review your registration file and email you a valid license key.
Once you receive the key, perform the following:
1. Save the file to the top level (root directory) of a USB Drive.
2. Insert the USB drive into the USB port on the vision screener.
3. From the Tools menu, select License. After a moment, a dialog box will appear
indicating that the license file has been imported onto the device.
If you have enabled security on your device, the password will be your four-digit
pin code.
Setting up the Vision Screener 21