Configuration Using Hart - Eclipse 705 Installation And Operating Manual

CONFIGURATION USING HART

-
+
Junction
250 Ω < R < 450 Ω
L
-
Control
Room
Display
Power
Supply
Current
Meter
®
CONNECTIONS
Connection of your Hart communicator:
• at power terminals (+) and (-) in wiring compartment
• at first junction box between unit and control room.
IMPORTANT: The digital HART
4-20 mA loop and requires a min. load resistance of 250 Ω and a max load
resistance of 450 Ω.
CHECK HART
®
Before starting the HART
nicator is equipped with the proper Eclipse Device Descriptors (DD's).
+
I/O
Select NO:
Select 4:
Select 5:
Check manufacturer: Magnetrol
HCF Release Date
September 2008
February 2013
When the proper software version is not found, consult your local HART
Center to load the correct Eclipse DD's.
HART MENU
I/O Start up the device
1 Enter Device Set Up «
Press one of the following alphanumeric keys (if no key is sensed after 5 s, the
unit will automatically jump to RUN mode and alternatively show Level/% Output
and Loop signal
1 for entering Calibration «
tion)
2 for entering Basic Set Up «
3 for Advanced Set Up «
mation)
4 for entering Diagnostics «DIAGNOSTICS» (see page 24 for additional infor-
mation)
5 for entering Review «
communication is superimposed on the
®
configuration procedure – check if your HART
®
start up the communicator
go offline
utility
simulation
Model
HART Version
Dev V1 DD V2
705 3.x
Dev V2 DD V2
»
DEVICE SET UP
» (see page 24 for additional informa-
CALIBRATION
BASIC SET UP
» (see page 24 for additional infor-
ADVANCED SET UP
» to review all settings.
REVIEW
commu-
®
Compatible with software
Version 3.0A and later
Version 3.2A and later
Service
®
» – general HART
23