Eclipse 705 Installation And Operating Manual page 10

CONFIGURATION
NOTE: When connected to an approved barrier, the intrinsically safe electronics of the Eclipse allow to remove the
covers with power switched on – even if the area is known to be hazardous
Display
Units
cm
Units!
cm
Units
cm
PASSWORD
DISPLAY
Ent Pass
0
Ent Pass!
1
New Pass
4096
NOTE: Password protection is activated when after 5 minutes no keystrokes are sensed.
10
2 line – 8 characters LCD
Default display cycles every 5 s through Status «STATUS» / Level
«LEVEL» / % output «% OUTPUT» / Loop «LOOP».
Up/Down and Enter pushbuttons
IMPORTANT: The Eclipse amplifier can be bench configured without GWR
probe connected. Ignore the start up message «No Level Signal» / «STA-
TUS» / «WeakSgnl» in this case.
Action Comment
The last character on the first line of the display changes to «!». This sign con-
Press :
firms that the values/choices of the second line can be modified via the
push buttons.
* Scroll through the choices or increase/decrease the values on the second line
Press
of the display by
* Accept values/choices as selected by
Scroll through the menu.
Press
ACTION
Display shows «0»
Press and last character changes into «!»
Enter your personal password with
(any value between 1 and 255)
Press to confirm
Press and enter old password
Press and last character changes into «!»
Enter your new password with
(any value between 1 and 255)
Press to confirm
Display shows an encrypted value, enter your password
or call Magnetrol for assistance to recoop your password
if necessary
and pushbuttons.
pushbutton.
and
and
and
COMMENT
Factory default setting
Data is not protected
Setting password
Changing password
Data is protected by a valid
Password