12-Pin Accessories Harness - Autostart AS-6205 SH Installation Manual

"under crank".
GRAY
Connect this wire to the Hood Pin-switch supplied. This input will disable or
(-) Hood
shut down the Remote Starter when the Hood is opened. It is also used for
3
Switch
programming and therefore it is essential that it is installed.
input
This wire must be connected to the Brake Light switch of the vehicle. The
ORANGE
wire should be +12 V only while the Brake Pedal is pressed. This input will
(+) Brake
4
Switch
shut down the Remote Starter if the Brake Pedal is pressed. It is also used
input
for programming and therefore it is essential that it is installed.
This wire provides a +12 V output (15 A max.) and must be connected to
YELLOW
the Parking Light wire that tests +12 V when the Parking lights are
+12 V
Note: Ensure that the voltage does not vary when the dimmer control
5 Parking
switch is turned up or down. If this is the case, it is not the right wire.
Light
There is also a negative Parking Light output. Only one of these
output
two different outputs needs to be connected.

12-Pin Accessories Harness

Wire
500 mA negative output. This output can be used to control Trunk
release (1-sec. pulse) or can be set to operate as a constant output as
BLUE
long as the
(–) AUX 3
1
(Trunk)
close).
output
Note:
vehicle is running under remote control.
BROWN
Programmable 500 mA, 1/10-sec., 7/10-sec. or 4-sec. negative output.
2 (–) Lock
output
GREEN
Programmable 500 mA, 1/10-sec., 7/10-sec., 4-sec. or a double ¼-sec.
3 (–) Unlock
pulse negative output.
output
500 mA ground output when the
WHITE /
activated 500 ms before the
BROWN
the
4
LOCK
(–) Arm
Note: The system will also give an
output
shuts down the vehicle after a remote start.
WHITE /
500 mA ground output when the
GREEN
5 for disarming OEM Alarm systems.
(–) Disarm
Note: System will also give a
output
This input should be used in vehicles that use a positive-switching
Dome Light circuit. Connect to a Dome Light wire testing +12 V with a
Door open.
BLUE /
CAUTION! You can only use a negative or a positive connection. In
WHITE
6 other words, only the NEGATIVE DOOR INPUT or the POSITIVE
(+) Positive
DOOR INPUT wire is connected. It is essential that the Module be
Door input
connected in such a way as to allow each one of the Doors to turn off
Ready Mode: the driver-side Door Pin does not constitute by itself a
sufficient connection
P.6
Description
button is held pressed. (For Sunroof or Window
TRUNK
( ) operates only when Ignition is
AUX3 TRUNK
LOCK
pulse and deactivated 250 ms after
LOCK
pulse ends.
ARM/REARM
UNLOCK
DISARM
.
ON
or when the
OFF
button is pressed. This output is
pulse on this wire when it
button is pressed. This wire is
pulse before remote start.
Installation Guide AS-6205 SH