Intrusion Codes; Intrusion Codes Via Led Light; Chirps - Autostart AS-6205 SH Installation Manual

10 x = Alarm condition
Note: "x" stands for one flash of the Parking Lights

Intrusion Codes via LED light

If there has been an intrusion in the vehicle while it was locked and armed, the LED will
provide an intrusion code corresponding to the type of the intrusion which took place. The
LED intrusion codes are flashed in continuous loops. They are the same codes as those
provided during Events Playback:
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead...
2 x = Doors intrusion

Chirps

Chirps
1
2
3
4
5
Constant up to 30
seconds
Constant up to
60 seconds
AS-6205 SH Installation Guide

Intrusion Codes

1 x = Power-up Reset: Battery
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Description
and the system.
LOCK ARM
.
confirmation
LOCK
Entering Mode 1 in Programming Options.
Start attempt when the Engine is already running under remote control.
Disarmed Notification
and disarm.
UNLOCK
Transmitter Programmed.
Entering Mode 2 in Programming options.
and arm while a zone is left unprotected.
LOCK
Entering Mode 3 in Programming Options.
Door zone left unprotected.
and disarm: an intrusion was detected.¸
UNLOCK
Entering Tach-learning Mode.
Siren or Horn Chirp Timing adjustment
Panic Mode causes the Horn/Siren to sound.
Alarm condition generated by an intrusion, by triggering Panic Mode, or
when the Module is powered up.
disconnected / reconnected or
dead...
P.19