Setup Menu; Patient Setup Menu; Clinical Setup Menu - ResMed VPAP ST Clinical Manual

Setup menu

The Setup menu consists of:
• Patient Setup menu—allows the patient to optimise comfort settings as well as make changes to
the mask or tube type.
• Clinical Setup menu—allows you to set all parameters pertaining to the patient's therapy.

Patient Setup menu

Only settings relevant to the patient are displayed in the Patient Setup menu. Depending on how the
device has been customised via the Clinical Setup menu, the following screens can be viewed:
+

Clinical Setup menu

To access the Clinical Setup menu, press and hold the Setup button and push dial for three seconds.
There are four screens available from the Clinical Setup menu as shown in ST mode below:
Tube—only displayed if ClimateLine/ClimateLine
ClimateLine/ClimateLine
Climate Ctrl—only displayed if ClimateLine/ClimateLine
also set to PATIENT in the Clinical Setup menu.
Mask—always available.
Mask Fit—always available.
Leak Alert—only displayed if set to PATIENT in the Clinical Setup menu.
SmartStart—only displayed if set to PATIENT in the Clinical Setup menu.
Settings
Displays parameters directly affecting the patient's therapy.
Note: Clinical menus are identified by the yellow open lock shown in the
top right corner. Where further options exist on a screen, the blue scroll bar
down the right of the screen indicates your position within these options.
Options
Displays parameters affecting the patient's comfort, therapy feedback and
compliance reporting.
Reminders
Displays parameters for accessories requiring replacement.
Configuration
Displays general device setting and resetting options.
is attached, no setting is required.
MAX
is not connected. If
MAX
is connected and
MAX
17
English