Cleaning And Maintenance; Disassembling The H5I; Daily; Monthly - ResMed VPAP ST Clinical Manual

Cleaning and maintenance

You should regularly clean and maintain your device as described in this section.

Disassembling the H5i

1. Slide the latch.
2. Lift open the flip lid.
3. Remove the water tub.
4. Discard any excess water from the water tub.
5. Unclip all four side latches.
6. Pull apart the tub lid, plate and base.

Daily

1. Remove the air tubing by pulling on the finger grips on the cuff. Hang the air tubing in a clean, dry
place until next use.
2. Wash the disassembled tub lid, plate and base in warm water using a mild detergent.
3. Rinse thoroughly in clean water and allow them to dry away from direct sunlight.
Notes:
• The disassembled tub lid, plate and base may also be washed in a dishwasher on the delicate or
glassware cycle (top shelf only).
• Do not hang the air tubing in direct sunlight as it may harden over time and eventually crack.
• Do not wash the air tubing in a washing machine or dishwasher.

Monthly

1. Wipe the exterior of the VPAP and H5i with a damp cloth and mild detergent.
2. Check the air filter for holes and blockage by dirt or dust. Replace the air filter if necessary.
3. Peel the flip lid seal from the flip lid and wash it in warm water using a mild detergent.
28