Table of Contents
Advertisement
9. Assemble the Lid
a. Pop the Console and Top onto the cabinet (40, 41). Looks pretty neat, huh? If needed, touch
up the Console or the Sides with fine sandpaper to achieve the nicest-looking fit you can.
40
b. Remove the Top and carefully apply a tiny, continuous bead of glue to the top edge of the
Console (42). Take particular care not to use too much glue at the ends, near the Sides. If the
glue oozes out, it could stick the lid to the Sides. Replace the Top and press it gently down
onto the Console (43). Hold it for at least a minute, then let it set for at least 30 minutes, until
the glue is well-set.
42
c. If you feel it is necessary, reinforce the Lid with an additional bead of glue on the inside of
the joint (44). Let the lid cure thoroughly before putting it back on the synth (45).
44
41
43
45
44
Advertisement
Table of Contents
