Table of Contents
Advertisement
9. Fold and glue the hems. Tabs A & B are hems, meaning they are to be folded over flat and
glued down. Pre-crease them sharply (21). Apply rubber cement, following directions on the jar
for the strongest bond (22). Fold the tabs flat and clamp them down with large paper clips or
small binder clips (23). Now leave it alone until the glue dries thoroughly. Play with your synth.
21
23
10. Apply the label.
a. Clean up any dust or stray paper bits from your workspace.
b. Cut out the main control panel label, around the outside of the white border (25).
c. Poke pinholes through the label at the crosshairs for the far left and right pots. Be very
precise! (26).
25
22
24
26
30
Advertisement
Table of Contents
