Table of Contents
Advertisement
2. Prep the parts.
a. If any parts in your kit are attached to each other, do not break them apart; slice or chop
them with your knife. Shave off and sand down all the tabs, flash and machining ripples
from all parts (2, 3).
2
b. Console: You may want to sand the long edges of the Console as shown to create a 60
degree bevel (4); this may not be necessary depending on how your console piece fits. Be
careful to create a parallelogram, not a trapezoid (5). When complete, the console should fit
neatly against the sloped faces of the cabinet Sides (6), flush to the top (7).
4
6
3
5
7
37
Advertisement
Table of Contents
