Table of Contents
Advertisement
7. Install the synth.
a. Remove the two front standoffs from your Macchiato PCB (23). Install them in the front two
holes in your cabinet, using the tiny plastic washers under the cabinet Bottom (24,25).
23
25
b. Point the ON/OFF switch at its hole in the cabinet Back and slide the synth into place (26).
Make sure the ON/OFF switch works easily. If it sticks, or rubs in its hole, remove the synth
and enlarge the hole a little with the tip of your knife.
26
c. Now run screws with washers up through the cabinet Bottom and into the remaining three
standoffs (27). Finally, screw the PCB down to the front two standoffs (28).
27
24
28
41
Advertisement
Table of Contents
