Table of Contents
Advertisement
d. Place the Top onto the completed PCB so all nine pots and the LED stick through (34). Place
the label down over the pots as well. When you like how it lines up, use binder clips or tape
to secure one end of the label (35).
34
e. Peel and tear off about half of the backing (36). Carefully stick that end of the label down to
the Top (37). Smooth out any bubbles or wrinkles.
36
f.
Now remove the binder clips and the last of the backing (38). Smooth down the label (39).
38
35
37
39
43
Advertisement
Table of Contents
