Table of Contents
Advertisement
b. Pick up one magnet on the tip of your knife (17). Dry fit it into each one of the pits on the
cabinet Sides. If necessary, clean up the bottom of the pits so that the magnet sits flat at the
bottom (18).
17
c. Place a tiny drop of Super Glue in one of the pits. Quickly place a magnet MARKED SIDE
UP in the pit and hold it down with a toothpick or pencil tip (19).
Repeat for the other pits in the Sides (20). Place all four magnets with MARKED SIDE UP.
19
d. Dry fit the remaining magnets into the little round divots in the Top and Console. They should
fit fine, but it is smart to check. In fact, the fit may be tight, which is good. Place a droplet of
Super Glue in a divot (21) and place a magnet MARKED SIDE DOWN (22)! If necessary,
press the magnet into place with the eraser end of a pencil. Repeat for the last three
magnets. Let the Super Glue cure for a few minutes before continuing, or the magnets will
pull each other out of their sockets.
21
18
20
22
40
Advertisement
Table of Contents
