Table of Contents
Advertisement
11. MIDI IN Jack (P3): Press it snug to the board. Double check it is flat against the board and then
solder it in (52,53).
52
12. Power Switch (S1): Before you place the power switch on the board, push the little red button
onto the switch (54). Press the switch snug to the board and solder the leads (55,56).
54
56
13. Potentiometers (VR1 - VR9): Install the control pots. You will manipulate these components
more than any other, so be careful to seat them securely against the PCB (57,58). Solder them
carefully and securely (59). Do not use too much heat. If you cannot move quickly with your iron,
place all nine pots in the board and solder one pin on each pot sequentially. This will allow each
pot to cool before you solder its next leg (60).
53
55
22
Advertisement
Table of Contents
