Table of Contents
Advertisement
4. Cut out the template.
a. Using sharp scissors, or a metal ruler and an X-Acto knife, carefully cut out the whole
perimeter of the template (9,11). Additionally, snip along every solid line near tabs G
through L (10).
9
11
b. Cut slits in Tabs C & D. Carefully cut along the solid lines with the tip of your blade (12).
5. Cut out some of the holes.
a. Cut out the five tiny screw holes from the cabinet bottom. It's okay if the holes are a little
small, but do not cut them too big (13)!
b. Cut out the four holes from the cabinet back (14). Cut to the outside of the markings; it is
important not to undersize these holes.
13
10
12
14
28
Advertisement
Table of Contents
