Table of Contents
Advertisement
15. Speaker (SP1): Place the speaker into its holes. The pin marked "+" on the bottom of the speaker
goes into the hole closest to the corner standoff. This is marked on Figure 3. Solder the leads
(70, 71).
70
16. Serial Number Label (Part #PL-10-90): Clean the PCB with rubbing alcohol to remove fingerprints
and solder residue (72). In addition to the sticker site, clean the keyboard area as well. Apply
the serial number sticker (73). Rub it down thoroughly. You will need this number if you request
assistance or service.
72
Congratulations! Your Macchiato Mini-Synth is complete, except for the cabinet. I know you are eager
to hear cool sounds, so open up the "Macchiato Quick-Start Guide" and make some noise. Keep the
label sheet handy so you can keep track of the many knobs. When you are ready to protect your
wonderful new synthesizer in its own cabinet, continue on.
71
73
25
Advertisement
Table of Contents
