Table of Contents
Advertisement
h. Remove the binder clips; remove the last of the backing (32); stick the label onto the cabinet
(33). If your cardstock has a textured surface, you may need to warm the sticker with a hair
dryer and burnish it down thoroughly.
32
11. Cut out the label holes.
a. Cutting through the label and down into the cabinet, cut out the nine pot holes and the LED
hole. Completely remove the black dots, leaving the white rings (23, 24). Alternatively, you
could use a 1/4" round hole punch, but you will have to be very precise since the punched
holes will not be much larger than the pot shafts.
34
b. Carefully cut out the five speaker slots, taking care not to cut across the ribs (23). Stay just
inside the white lines.
36
33
35
37
32
Advertisement
Table of Contents
