Table of Contents
Advertisement
3. Glue the Sides to the Bottom.
a. Dry fit the Sides to the Bottom (8a). Note how the Bottom sits flush to the slots in the Side,
both toward the front and the rear (9b). Run a tiny bead of glue inside the slot along the
bottom edge of one Side (8b). Press the Side into place. Squeeze it firmly and hold it for
about a minute until the cement grabs (9a). Be careful to hold it perpendicular to the Bottom.
Repeat for the other Side, then leave it all alone for at least ten minutes, or as your glue
instructions direct.
8a
9a
4. Install the Back.
a. Dry fit the Back into place (10). Be sure to place it flush to the top edge of the Sides.
b. Apply glue to the slots in the Sides (11). Apply a tiny bead of glue along the back edge of
the Bottom. Be sparing, or you will make a mess.
10
8b
9b
11
38
Advertisement
Table of Contents
