Table of Contents
Advertisement
14. Install the Synth.
a. If desired, pop a 9V DC battery into the battery holder. Now fit the synth into the cabinet,
tight to the front (44).
b. Fold up the back, carefully fitting the red ON/OFF button through its hole (45).
44
c. Close the lid over the nine pots. The LED should appear in its hole too. If it does not line up,
open the lid again and push the LED around to line it up with its hole. Also check the ON/
OFF switch: does it pop in and out as it should? If not, carefully enlarge its hole a little.
d. Tuck Tabs C & D into the cabinet behind Tabs K & L (46). Direct Tabs K & L into the slots
in Tabs C & D (47). They may require some gentle persuasion. Be patient and gentle. If
necessary, clear or lengthen the slots in C & D with the tip of your knife. When Tabs K & L
slip into place, they will neatly lock the cabinet closed (48). You can open the cabinet up
again to change the battery by gently teasing Tabs K & L out with a fingernail. Do this as
seldom as possible, or you will wear out the tabs.
46
48
45
47
34
Advertisement
Table of Contents
