Measure Mode; Measurement Ranges - Fluke 753 User Manual

5. The ID string is shown at the bottom of the boxed area.
To erase a character, push the Back Space softkey. To
erase the complete string, push . Information
recorded in the ID string is recorded with all
measurements stored in memory.
6. Push , , , or  to select a character, then push
. Use the numeric keypad to record numbers.
7. Do step 6 until satisfied with the ID string.
8. Push the Done softkey.
9. Push the Done softkey or s to exit Setup mode.
Find Quality Products Online at:

Measure Mode

To get the best noise rejection and highest
accuracy performance when you measure, use the
battery; do not use the battery charger.
The operation mode (for example, MEASURE, SOURCE) is
shown in the top left of the display. If the Product is not in
MEASURE mode, push  until MEASURE is shown. The
Product must be in MEASURE mode to change the
MEASURE parameters.

Measurement Ranges

The Product usually changes to the correct measurement
range automatically. The lower left side of the display shows
"Range" or "Auto" if on the range status. Auto Range switch
points are shown in Specifications. When the Range softkey
is pushed, the range is locked. Push it again to go to and
lock on the next higher range. Auto Range is in operation
when a different measurement function is selected.
If the range is locked, overrange inputs show on the
display as - - - - - -. In Auto Range, out of range is
shown as ! ! ! ! ! !.
GlobalTestSupply
www.
Documenting Process Calibrator
Measure Mode
Note
.com sales@GlobalTestSupply.com
29