Measurement Commands - Omega CL3001 User Manual

Output Commands
Command
OPER
OPER?
OUT
OUT?
RANGE?
RANGELCK
RANGELCK?
STBY

Measurement Commands

Command
ISO_MEAS
PRES?
PRES_MEAS
RTD_MEAS
TC_MEAS
VAL?
ZERO_MEAS
ZERO_MEAS?
RS-232 Operating Mode Commands
Command
LOCAL
LOCKOUT
REMOTE
Description
Activates the CL3001 output if it is in standby mode.
Returns the operate/standby mode setting.
Sets the output of the CL3001.
Returns the present output value of the CL3001.
Returns the present output range, for voltage and current
only.
Locks the present output range, for voltage only.
Returns the RANGELOCK state, for voltage only.
Deactivates the CL3001 output if it is in operate mode.
Description
Sets the isolated input measurement type.
Queries the attached pressure module for its
manufacturer and serial number.
Changes the operating mode of the primary display to
pressure measurement.
Changes the operating mode to RTD measurement.
Changes the operating mode to thermocouple
measurement.
Returns the last values for the isolated and primary
measurements, in that order.
Zeros the pressure module, TC mV, or RTD ohms.
Returns the zero offset for the pressure module, TC mV,
or RTD ohms.
Description
Puts the CL3001 into the local state and disables
lockout.
Puts the CL3001 into the lockout state. This command
duplicates the IEEE-488 LLO (Local Lockout) message.
Puts the CL3001 into the remote state. This command
duplicates the IEEE-488 REN (Remote Enable) message.
59