Rear Panel - Omega CL3001 User Manual

Lab calibrator

Table of Contents

Input Terminals

Note 1:

These terminal binding posts are made of a special copper alloy

to reduce thermal EMF's. They support the use of either discreet

wires or standard banana plugs, and the HI/LO pairs are spaced

for standard dual banana plugs.

Note 2:

Caution. Do not exceed a maximum of 100 volts to chassis

ground.

2.5 Rear Panel

Figure 5 describes the rear panel layout.

Figure 5 - Rear Panel

resistor.Note that activating this

resistor drops the maximum load

driving capability from 1000 ohms at

20mA to 750 ohms at 20mA.

Select Pressure input mode.

Subsequent presses of this key

cycle through the pressure

units.Pressure input mode uses the

pressure module connector on the

primary input/output side. Both

sides may be selected to pressure

mode simultaneously and can be

set to display the same pressure

measurement in different units if

desired.

Common input terminals for DC

voltage and current. See notes 1

and 2 below.

Table of Contents