Safety Instructions - ColorKey MobilePar Hex 4 User Manual

PRESETS
The following table describes in basic terms each of the 68 program presets built
into the fixture. The SP-- value determines the speed of any color cycling, flashing,
or fading.
Pr- - Function Pr- - Function
00 R 23 G+B+A
01 G 24 R+G+W
02 B 25 R+B+W
03 A 26 G+B+W
04 W 27 R+A+W
05 UV 28 G+A+W
06 R+B 29 R+G+UV
07 G+B 30 R+B+UV
08 R+A 31 G+B+UV
09 G+A 32 R+A+UV
10 B+A 33 G+A+UV
11 R+W 34 B+A+UV
12 G+W 35 R+W+UV
13 B+W 36 G+W+UV
14 A+W 37 B+W+UV
15 R+UV 38 A+W+UV
16 G+UV 39 R+G+B+A
17 B+UV 40 R+G+B+W
18 A+UV 41 R+G+A+W
19 W+UV 42 G+B+W
20 R+G+B 43 R+B+A+W
21 R+G+A 44 G+B+A+W
22 R+B+A 45 R+G+B+UV
Pr- - Function
46 R+G+A+UV
47 R+B+A+UV
48 G+B+A+UV
49 R+G+W+UV
50 R+B+W+UV
51 G+B+W+UV
52 R+A+W+UV
53 G+A+W+UV
54 B+A+W+UV
55 R+G+B+A+W
56 R+G+B+A+UV
57 R+G+B+W+UV
58 R+G+A+W+UV
59 R+B+A+W+UV
60 G+B+A+W+UV
61 R+G+B+A+W+UV
62 R+G
63 All Off
64 6 color flash change
65 6 color flash change + strobe
66 multicolor flash change
67 multicolor flash change +strobe
Page 10

SAFETY INSTRUCTIONS

Please read these instructions carefully. They include
important information about the installation,usage and
maintenance of this product.
Please keep this User Guide for future use. If you sell the unit to someone else, be sure
that they also receive this User Guide.
ALWAYS make sure that you are connecting to the proper voltage, and that the line
voltage you are connecting to is not higher than that stated on the decal or rear panel of
the fixture.
This product is intended for indoor use only.
To prevent risk of fire or shock, do not expose fixture to rain or moisture.
Make sure there are no flammable materials close to the unit while operating.
The unit must be installed in a location with adequate ventilation, at least 20" (50cm) from
adjacent surfaces. Be sure that no ventilation slots are blocked.
ALWAYS disconnect from the power source before servicing or replacing fuse and be
sure to replace with same fuse size and type.
ALWAYS secure fixture using a safety chain. NEVER carry the fixture by its cord. Use its
carrying handles.
DO NOT operate at ambient temperatures higher than 104°F (40°C).
In the event of a serious operating problem, stop using the unit immediately. NEVER try to
repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center. Always
use the same type spare parts.
NEVER connect the device to a dimmer pack.
Make sure the power cord is never crimped or damaged.
Never disconnect the power cord by pulling or tugging on the cord.
Avoid direct eye exposure to the light source while it is on.
Caution! There are no user serviceable parts inside the unit. Do
not open the housing or attempt any repairs yourself.
Page 3