Rom Problems - HP CL2100 G3 807S User And Maintenance Manual

Errors occur after the system software is changed
Change settings to the original configuration. If more than one setting is changed, change the settings one
at a time to isolate the cause of the problem.
Errors occur after an application is installed
Check the application log and operating system log for entries which may indicate why the software
1.
failed.
Check system settings to determine if they are the cause of the error. You might need to obtain the
2.
settings from the server setup utility and manually set the software switches. See the application
documentation, the vendor website, or both.
Check for overwritten files. See the application documentation to find out which files are added by
3.
the application.
Reinstall the application.
4.
Be sure you have the most current drivers.
5.

ROM problems

Remote ROM flash problems
Command-line syntax error
1.
If the correct command-line syntax is not used, an error message describing the incorrect syntax is
displayed and the program exits. Correct the syntax, and then restart the process.
Access denied on target computer
2.
If you specify a networked target computer for which you do not have administrative privileges, an
error message is displayed describing the problem, and then the program exits. Obtain
administrative privileges for the target computer, and then restart the process. Be sure the remote
registry service is running on a Windows
Invalid or incorrect command-line parameters
3.
If incorrect parameters are passed into command-line options, an error message describing the
invalid or incorrect parameter is displayed and the program exits (Example: Invalid source path for
system configuration). Correct the invalid parameter, and then restart the process.
Network connection fails on remote communication
4.
Because network connectivity cannot be guaranteed, it is possible for the administrative client to
become disconnected from the target server during the ROM flash preparation. If any remote
connectivity procedure fails during the ROM flash online preparation, the ROM flash does not occur
for the target system. An error message describing the broken connection displays and the program
exits. Attempt to ascertain and correct the cause of connection failure, and then restart the process.
Failure occurs during ROM flash
5.
The flash cannot be interrupted during this process, or the ROM image is corrupted and the server
does not start. The most likely reason for failure is a loss of power to the system during the flash
process.
Updating firmware
6.
To update the firmware (BIOS FW, BMC FW, HBA card FW, HDD FW, and so on):
Check the firmware version on the device.
o
®
-based system.
Diagnostic flowcharts 89