Table of Contents
Advertisement
Press the power button on the front control panel to power up the server.
1.
Press F2 or DEL during system boot when the Press <DEL> or <F2> to enter setup displays.
2.
Use the left and right arrow keys to navigate the different menu options. When a menu option is
3.
selected, the top-level screen for that option appears.
Use the up and down arrow keys to scroll up and down to select an item on a top-level screen. When
4.
the up and down arrow keys are pressed, the only options that are highlighted are the options that
can be modified.
If an item can be modified, user instructions for modifying the option appear in the right column of
o
the screen.
If an item is a link to a sub-screen, a prompt to press Enter to access the sub-screen appears in
o
the right column.
Modify the setup item and press F4 to save the changes and exit the screen.
5.
Follow the instructions on the Save & Exit menu screen to save or discard your changes and exit the
6.
BIOS setup utility.
BIOS beep codes
This section provides the BIOS beep codes including the PEI to report errors during memory initialization
and DXE to report errors during hardware initialization.
PEI beep codes
Beep Numbers
1
1
2
3
4
5
7
DXE beep codes
Beep Numbers
1
4
6
7
8
BIOS maintenance
This section provides information about upgrading the BIOS, clearing the BIOS password, clearing
CMOS, BIOS recovery, and a BIOS jumper description.
Description
Memory was not installed
Memory was installed twice (Install PEI memory routine in PEI core was called twice)
BIOS recovery started
DXE IPL was not found. Cannot locate DXE IPL PPI
DXE core firmware volume was not found. Cannot load DXE core file into memory
BIOS recovery failed
No memory detected
PEI reset is not available
Description
Invalid password
Some of the architectural protocols are not available
Flash update failed
DXE reset is not available
Platform PCI resource requirements cannot be met
Configuration 54
Advertisement
Table of Contents
Troubleshooting
