Installing The Heat Sink - HP CL2100 G3 807S User And Maintenance Manual

Remove the heat sink.
4.
Repeat the procedure for the additional heat sink.
5.

Installing the heat sink

CAUTION:
system board.
To install the heat sink
Make sure the top of the processor is clean.
1.
Apply a small drop of thermal compound in the middle of the processor.
2.
Remove the protective cover from the underside of the heat sink.
3.
Align the heat sink so the sticker label faces the DIMM module.
4.
Place the heat sink on top of the processor until it is seated firmly in place.
5.
To secure the heat sink, tighten the four retaining screws clockwise, in the order shown.
6.
Processor0
Do not apply an excessive amount of thermal compound to prevent damage to the
Processor0
Processor1
Processor1
Installation 30