Cpu Load Order; Installing A Cpu And Heat Sink Module - HP Integrity rx2800 - i2 User's & Service Manual

Quad-core CPUs:
1P/4C
2P/8C
The first CPU must be installed in socket 0, and the second CPU in socket Module 1.
CAUTION:
and cache size must be identical for all CPUs in a server. To ensure compatibility, whether
upgrading, replacing, or adding an additional CPU, use CPUs with identical part numbers.
Failure to observe this caution results in performance degradation or server failure.
CAUTION:
ESD safety precautions can result in damage to the server.

CPU load order

The server holds up to two dual or quad-core CPUs on the CPU board. The slots on the system
board are labeled Module 0 and Module 1. If the server has only one CPU, it is installed in socket
0. Install the second CPU in socket 1.
See Figure 2 (page 11)
Table 15 CPU load order
Processor
0
1

Installing a CPU and heat sink module

CAUTION:
replacing the system board.
CAUTION:
out before installation.
CAUTION:
bottom of the CPU, especially the contact area.
CAUTION:
configurations must contain CPUs with the same part number.
CAUTION:
from the heat sink after assembling.
The CPU and heat sink ship as separate units and are coupled during installation into the server.
38 Installing the server
Intel quad-core CPUs cannot be intermixed with similar dual-core CPUs. CPU speed
Observe all ESD safety precautions before attempting this procedure. Failure to follow
for the CPU socket numbers.
Socket
Module 0
Module 1
The pins on the CPU socket are very fragile. Any damage to them may require
To avoid damage to the CPU, verify that the plastic tabs on the CPU are pulled fully
To avoid damage to the CPU, handle the CPU only by the edges. Do not touch the
To prevent possible server malfunction and damage to the equipment, multiprocessor
To prevent thermal instability and damage to the server, do not separate the CPU