3: Adding/Removing The Device - FIBARO FGCD-001 Operating Manual

#3: Adding/removing the device

Adding (Inclusion) - Z-Wave device learning mode, allowing to add
the device to existing Z-Wave network.
To add the device:
1. Place the device within direct range of the Z-Wave controller.
2. Set the main Z-Wave controller in (security/non-security) adding
mode (see the controller's manual).
3. Quickly, triple click the button located on the casing.
4. Wait for the device to be added into the system.
5. Successful adding will be confirmed by the Z-Wave controller's
message.
Removing (Exclusion) - Z-Wave device learning mode, allowing to
remove the device from existing Z-Wave network.
To remove the device:
1. Place the device within direct range of the Z-Wave controller.
2. Set the main Z-Wave controller in remove mode (see the
controller's manual).
3. Quickly, triple click the button located on the casing.
4. Wait for the removing process to end.
5. Successful removing will be confirmed by the Z-Wave controller's
message.
Button
ADDING/REMOVING THE DEVICE
5
i
NOTE
When powered, the
device will indicate
Z-Wave status with
colour of LED:
• Green - the device is
already added to the
Z-Wave network.
• Red - the device is
not added to any
Z-Wave network.
i
NOTE
In case the device is
not added, please re-
set the device and re-
peat the adding pro-
cedure.
i
NOTE
When changing the
Sensor's location, it's
recommended to wake
up the device and re-
configure the Z-Wave
network by clicking
the button.
i
NOTE
Removing the device
from the Z-Wave net-
work restores all the
default parameters of
the device.