Related Manuals for FIBARO FGBHFS-001
Summary of Contents for FIBARO FGBHFS-001
-
Page 1: Table Of Contents
O P E R A T I N G M A N U A L FIBARO FLOOD SENSOR FGBHFS-101 CONTENTS v1.1 #1: Description and features #6: Functionalities #2: Powering the accessory #7: Configurable parameters #3: Pairing the accessory #8: Specifications... - Page 2 HomeKit-enabled accessories using Siri on your iPhone, iPad, or iPod touch. After installing your FIBARO Flood Sensor, configure it from a compatible app with just a few simple steps. You can even create your own custom scenes to control your home settings.
-
Page 3: 1: Description And Features
#1: Description and features FIBARO Flood Sensor is a HomeKit-enabled water sensor using Bluetooth® low energy technology. Along with detecting flooding, the accessory measures the ambient temperature. Tampering is detected whenever the accessory is moved or casing is opened. Built-in LeD indicator and an acoustic alarm signal flooding and tampering. -
Page 4: 2: Powering The Accessory
#2: Powering the accessory 1. Turn the cover counter-clockwise and open it. 2. Remove the battery blocker. NOTE if the accessory blinks 3. The accessory will glow red – it is ready to be paired. green after powering, it is already paired and 4. -
Page 5: 3: Pairing The Accessory
#3: Pairing the accessory 1. Open the Settings app on your iOS device. 2. Go to the Bluetooth® section, and turn the Bluetooth® on. 3. Place the accessory next to your iOS device. 4. Open a HomeKit compatible app of your choosing on your iOS device. -
Page 6: 4: Physical Installation
#4: Physical installation To install the Flood Sensor simply place it sensor on a surface prone NOTE to flooding. Before completing Three electrodes underneath the device should evenly touch the sur- the installation it is face. recommended to test sensor’s operation by placing the entire sen- sor or sensor probe Extending Flood Sensor contacts with a wired probe:... -
Page 7: 5: Reset
#5: Reset Resetting the Flood Sensor to factory defaults: Reset procedure allows to restore the accessory back to its factory settings including HomeKit pairing. 1. Open the cover. 2. Press the button 3 times then press and hold the button. Button 3. -
Page 8: 6: Functionalities
#6: Functionalities Flooding detection: The Flood Sensor alarms about flooding whenever water connects sensor’s probes and reports it to your iOS device. until the flooding does not cease, the accessory constantly beeps and blinks red signaling the alarm. Tampering signalization is ignored during the alarm. Tamper detection: The Flood Sensor detects tampering when the accessory is moved or casing is opened and reports it to your iOS device. -
Page 9: 7: Configurable Parameters
#7: Configurable parameters 1. Tamper – sensor sensitivity This parameter allows to set sensitivity of tamper detection. The higher the value of this parameter, the higher the sensitivity. if the installation surface is prone to vibrations, setting lower sensitiv- ity is recommended. Available settings: 0 –... -
Page 10: 8: Specifications
#8: Specifications Power supply: 3.0V DC battery CAUTION using batteries other Battery type: CR123A than specified may result in explosion. eu directives compliance: RoHS 2011/65/eu Dispose of properly, ReD 2014/53/eu observing environ- mental protection Radio protocol: Bluetooth® low energy rules. Radio frequency: 2.4 GHz up to 50m (free range) -
Page 11: 9: Regulations
#9: Regulations This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2. This device must accept any interference received, including inter- ference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. - Page 12 All information, including, but not limited to, information regarding the features, functionality, and/or other product specification are subject to change without notice. Fibaro reserves all rights to revise or update its products, software, or documentation without any obligation to no- tify any individual or entity.
- Page 13 Directive 2014/53/eu. The full text of the eu declaration of conformity is available at the following internet address: www.manuals.fibaro.com WEEE Directive Compliance Device labelled with this symbol should not be disposed with other household wastes.