FIBARO FGCD-001 Operating Manual page 13

Available settings: 0 - all actions disabled
Default setting:
4. Acoustic signals
This parameter allows to set the actions which result in acoustic sig-
nals. This parameter does not apply to the most important actions,
such as CO Alarm, Malfunction Alarm and Low Battery Alarm.
Available settings: 0 - all actions disabled
Default setting:
7. Associations in Z-Wave network security mode
Parameter defines how commands are sent in specified association
groups: as secure or non-secure. Parameter is active only in Z-Wave net-
work security mode. It does not apply to 1st "Lifeline" association group.
Available settings: 1 - 2nd group sent as secure
Default setting:
10. Commands sent to 2nd association group (CO Alarm)
This parameter defines commands sent to devices associated in 2nd
association group (CO Alarm). Values of specified commands may be
set in parameters 11 and 12.
Available settings: 1 - BASIC ON
Default setting:
11. Value of BASIC ON command sent to 2nd association group
This parameter defines the value of BASIC ON command sent to de-
vices in 2nd association group after the CO Alarm activation.
Available settings: 0-99 or 255
Default setting:
1 - tampering (opened casing)
2 - exceeding the temperature
4 - lack of Z-Wave range
0 Parameter size:
1 - tampering (opened casing)
2 - exceeding the temperature
4 - lack of Z-Wave range
0
Parameter size:
2 - 3rd group sent as secure
4 - 4th group sent as secure
8 - 5th group sent as secure
16 - 6th group sent as secure
32 - 7th group sent as secure
63 Parameter size:
2 - BASIC OFF
3 - BASIC ON & BASIC OFF
3 (ON & OFF) Parameter size:
255 (turn on) Parameter size:
1 [byte]
1 [byte]
1 [byte]
1 [byte]
2 [bytes]
ADVANCED PARAMETERS
13
i
NOTE
Parameter 3 values
may be combined, e.g.
1+2+4=7 means that
all actions will be ac-
tive.
i
NOTE
Parameter 4 values
may be combined, e.g.
1+2+4=7 means that
all actions will be ac-
tive.
i
NOTE
Parameter 7 values
may be combined,
e.g. 1+2=3 means that
2nd & 3rd group are
sent as secure.