Troubleshooting; Appendix; Disposal Of The Appliance; Notes On The Ec Declaration Of Conformity - Silvercrest SEF3 2000 A1 Operating Instructions Manual

Troubleshooting

GB
IE
PROBLEM
The appliance is not
working.
or
The Power control lamp 0
does not light up.
The Ready control lamp 9
does not light up.
If the malfunction cannot be corrected with the above suggestions, or if you have found some
other kind of malfunction, please contact our Customer Service department.

Appendix

Disposal of the appliance

Notes on the EC Declaration of Conformity

18
POSSIBLE CAUSE
The appliance is not connected
to a mains power socket.
The appliance is damaged.
The On/Off switch 8 has not
been activated.
The thermal cut-out has been
triggered.
The selected temperature for
the cooking oil/fat has not
been reached.
Under no circumstances should you dispose of the appliance in
normal household waste.
This product is subject to the provisions of European Directive
2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
With regard to conformity with essential requirements and
other relevant provisions, this appliance complies with the
guidelines of the Electromagnetic Compatibility Directive
2004/108/EC, the Directive for Low Voltage Appliances
2006/95/EC and the ERP Directive 2009/125/EC.
The complete Declaration of Conformity, in its original form, is
available from the importer.
POSSIBLE
SOLUTIONS
Connect the appliance to
a mains power socket.
Contact the Customer
Service department.
Press the On/Off switch 8.
Switch the device off at
the On/Off switch 8 and
disconnect the mains power
plug from the mains power
socket. Wait until the appli-
ance has cooled down.
Wait a few minutes until the
required temperature has
been reached.
SEF3 2000 A1