Docomo arrowsbe F-05J Instruction Manual page 126

◆ Scanning Wi-Fi network
･
Set Wi-Fi to ON in advance.
1
From the Home screen,
[Wireless & networks]→[Wi-Fi]
2 [MENU]→[Refresh]
◆ Adding Wi-Fi network
Enter network SSID or security information to add Wi-Fi
network manually.
･
Set Wi-Fi to ON in advance.
1 From the Home screen,
[Wireless & networks]→[Wi-Fi]
2 [Add network]
3
Enter a network SSID of Wi-Fi network to add
→Select security
･
Security can be set to [None], [WEP], [WPA/WPA2 PSK]
or [802.1x EAP].
4 Enter additional security information as
required→[SAVE]
◆ Deleting Wi-Fi network connecting
information
1
From the Home screen,
[Wireless & networks]→[Wi-Fi]
→[Settings]→
→[Settings]→
→[Settings]→
124
2
Select the connected Wi-Fi network→
[FORGET]
◆ Wi-Fi Easy Settings
You can connect through simple operations when connecting
via a Wireless access point supporting AOSS™ and WPS
connection.
･
Set Wi-Fi to ON in advance.
1 From the Home screen,
[Wireless & networks]→[Wi-Fi]
2
[MENU]→[Advanced]→[Easy Settings]
3 Select a registration method
AOSS™ system : [AOSS system]→Tap [AOSS] button→
Perform operations on the access point →On the
connection complete screen, [Finish]
WPS system : [WPS system]→[Push button system]/[PIN
entry system (8 digits)]/[PIN entry system (4 digits)]→
Perform necessary operations on the access point
･
In case of push button method, press a dedicated button
on an access point. In case of PIN entry method, enter
PIN code displayed on the terminal to an access point
device.
✔INFORMATION
･
For some wireless LAN access points, AOSS™ connection
may not be established. If connection is failed, use WPS
connection or connect manually.
･
When security on the wireless LAN access point is set to WEP,
you cannot connect in WPS system.
→[Settings]→
Settings