Programming The Radio; Programming Of Software Features And Flashing Of Radio Firmware - Motorola MTM700 Detailed Service Manual

PROGRAMMING THE RADIO

Programming of Software Features and Flashing of Radio
Firmware
SETING UP THE HARDWARE
The programming cable interfaces between the radio and an IBM PC (or compatible computer)
running the TETRA CPS. To perform the programming, proceed as follows:
1 Make sure the radio is turned off.
2 Connect the programming cable as illustrated on the following pages.
3 Turn the radio on. If your radio has only an expansion head without any control head, connect
pin 6 to pin 14 on the 25 pin connector on the expansion head front to switch on the radio and to
enter programming mode.
4 Run the Customer Programming Software (CPS) on your computer.
5 Select Tools/Options. Change the Communication setting according to the connection you are
using for the programming cable.
6 Follow the instructions on your PC.
7 After programming, remove the programming cable and in case you connected pin 6 to pin 14
on the 25 pin connector, remove this connection again. If the radio does not switch on automati-
cally or cannot be switched on using the On/Off knob or the Ignition input (pin 10 on the acces-
sory connector), disconnect the radio from the battery for about 2 seconds to exit the
programming mode.
Note: To program the radio, the following connector pins are used:
On the Accessory Connector
Pin
3
6
7
8
13
17
18
19
20
MTM700 Mobile Radio / Detailed Service Manual
Description
EXT PTT
Flash
Analog GND
Digital GND
SWB+
RS232 RTS (Radio Output)
RS232 CTS (Radio Input)
TX (Radio Output)
RX (Radio Input)
PROGRAMMING THE RADIO
On the 9-Pin Connector
Pin Description
2 RX
3 TX
5 GND
7 RTS
8 CTS
5 - 1
CHAPTER 5