Motorola MTM700 Detailed Service Manual page 100

6 - 6
9. Press the "Control Channel" soft key and enter "2040" ["840"] using the data keys fol-
10. Press the "Traffic Channel" soft key and enter "2040" ["840"] using the data keys.
11. Press the "Country Code" soft key.
12. Press the "Network Code" soft key.
13. Press the "Base Color" soft key.
14. Press the "Location Area" soft key.
15. Press the "Min Rx Level" soft key.
16. Press the "Max Tx Level" soft key.
17. Press the "Access Parameter" soft key.
18. Press the "Test Mode" soft key. Press the "Enable" soft key.
19. Press the "Base Service" soft key.
20. Press the "Suport" soft key if it is displayed
Note: The displayed values are factory defaults and should not be changed.
21. Press the "Return" soft key.
22. Press the "Neighbr Cell" soft key.
23. Verify that the following values are displayed:
MTM700 Mobile Radio / Detailed Service Manual
lowed by the "Control Channel" soft key.
Press the "Traffic Channel" soft key again and check that the marker goes to Time-
slot. Press data key "3" followed by the "Traffic Channel" soft key, to change to Time-
slot "3".
Enter "262" and press the "Country Code" soft key.
Thereafter, enter "75" and press the "Network Code" soft key.
Thereafter, enter "1" and press the "Base Color" soft key.
Thereafter, enter "224" and press the "Location Area" soft key.
Thereafter, enter "-120dBm" and press the "Min Rx Level" soft key.
Thereafter, enter "35dBm (3.2W)" and press the "Max Tx Level" soft key.
Thereafter, enter "-53dBm" and press the "Access Parameter" soft key.
or verify that the following values are displayed:
POWER ON REGISTRATION:
POWER OFF DE-REGISTRATION:
PRIORITY CELL:
MINIMUM MODE SERVICE:
MIGRATION:
SYSTEM WIDE SERVICE:
TETRA VOICE SERVICE:
CIRCUIT MODE DATA SERVICE:
(RESERVED):
SNDCP SERVICE:
AIR INTERFACE ENCRYPTION:
ADVANCED LINK:
REQUIRED
REQUIRED
YES
NEVER USED
SUPPORTED
NORMAL MODE
SUPPORTED
SUPPORTED
NOT AVAILABLE
NOT AVAILABLE
NOT AVAILABLE
NOT SUPPORTED
TEST SETUP & TESTING