1.0
Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and tuner
program designed for use in a Windows 98/ME/NT/2000 environment.
NOTE
Refer to the CPS on-line help files for programming procedures.
2.0
CPS Programming/Flashing Setup with RIB
The CPS programming setup, shown in Figure 4-1 is used to program and flash the radio using the
Radio front Telco connector.
FKN8096
Data =Programming
Boot = Flashing
RADIO TUNING AND PROGRAMMING
Table 4-1 Software Installation Kits Radio Tuning Setup
Description
CPS
8-pin Telco
FKN8096
10-pin Telco
Programming
Cable
DB25
3080070N01
Figure 4-1 CPS Programming/Flashing Setup with RIB
ACC
DC
Power
Supply
RF
DB15
RIB
RLN-4008
Cable 3080369B72 (9 PIN)
Cable 3080369B71 (25 PIN)
Chapter 4
Kit Number
RVN4191_
Tx Data
Rx
Data
Gnd