Table of Contents
Advertisement
1.0
Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and Tuner Software
which are designed for use in a Windows 95/98 environment. These programs are on the CD provided
with this manual. A Software Installation manual is also provided to guide through the installation
process.
NOTE
Refer to the appropriate program on-line help Þles for the programming procedures.
Software CD
Customer Programmable Software
Tuner Software
2.0
Radio Tuning Setup
A personal computer (PC) using Windows 95/98 and a tuner program are required to tune the radio.
To perform the tuning procedures, the radio must be connected to the PC, radio interface box (RIB),
and test equipment shown in Figure 5-1.
Battery
Eliminator
7.5V Reg.
RLN4510
+12VDC
Power
Supply
Battery Block
0180305H20
RADIO TUNING AND PROGRAMMING
Table 5-1 Software Installation and Radio Tuning Setup
Description
RF Adaptor
HLN9756
3,5 mm to
Ferrule BNC
Radio
10 dB Pad
Program / Test Cable
PMKN4004
AC Plug
120/230 Vac
RIB Power Supply
Figure 5-1 Radio Tuning Test Equipment Setup
T ransmit
Receive
Audio In
Test Box
RLN4460
DB15
DB9
RIB
RLN4008
Computer Interface
Cable 3080369B72
Chapter 5
Kit Number
ENLN4131_
ENVN4020_
ENVN4014_
Service Monitor
or Counter
Wattmeter
RF Generator
Tx
Audio Generator
Rx
Sinad Meter
AC Voltmeter
Tx Data
Rx
Data
Gnd
Hide quick links:
Advertisement
Table of Contents
