Canon iPF8400S Service Manual page 296

Chapter 8
Code
(last 4 digits)
2E0C Manual printing
is selected, but a roll is
loaded.
Press Load/Eject and
remove the roll.
Sheet printing
is selected, but
a roll is loaded.
Stop Printing
Sheet printing
is selected, but
a roll is loaded.
2E0E No Roll Feed Unit.
Turn printer off
and install roll
feed unit.
2E0F Top cover is open.
Turn off printer,
wait a while, and
turn it on again.
2E10 Ink tank cover
is open.
Turn off printer,
wait a while, and
turn it on again.
2E11 Carriage Cover is open.
2E12 Rel lever is in
wrong position.
Turn off printer,
wait, then
turn on again.
2E14 Wrong paper size.
Check paper size setting on
computer.
Online: Print
Stop: Stop Printing
Wrong paper size.
Check paper size
setting in driver.
Online: Print
Stop: Stop Printing
8-20
Panel display Panel display
(Large LCD) (Small LCD)
Tray Selected
Press OK
Roll P Unit
Please Check
Power On
Again
Top Cover
Please Close
Top Cover Open
Close Top Cover
Ink Tank Cover
Close Please
Tank Cover Open
Close Please
PaprSiz Mismatch
Prnt:PressOnline
Loaded Papr Diff
From Spfd Size
Driver: Chk Papr
Size Setting
Loaded Papr Diff
From Spfd Size
Explanation/Detection sequence
Paper mismatch (cut sheet)
1. Print data having a manual feed print
specification has been received at the
completion of roll paper pickup.
2. Print data having a manual feed print
specification has been received when there
is roll paper printout.
3. Cut sheet data has been received when
the media take-up unit is in use.
Roll paper unit not installed
The unit has received print data having a
roll paper print specification when it had
started without a roll unit being connected
to it.
The top cover is abnormally open.
Ink tank cover error open (continued use
allowed)
The ink tank cover opened while
performing any operation, such as printing
and suctioning.
Carriage cover open error
A carriage cover open has been detected.
Faulty release lever
The state of the release lever up (released)
has been detected.
Paper mismatch (size or width)
The paper size specified for the [Print to
meet the paper width] setting of the driver
on receiving print data and the width of the
roll paper actually fed did not match.
Remedial Action
Check the paper that is actually loaded
on the paper and the paper feed setting
of the driver.
1. Check the roll unit, and remove,
install or replace the roll unit.
2. Check I/O mode (roll unit
detection).
Check the cover.
Check the sensor (I/O mode).
Close the ink tank cover.
Check the sensor (I/O mode).
Close the carriage cover.
Check the sensor (I/O mode).
Push down the release lever.
Check the sensor.
Check the paper that is actually loaded
on the printer and the paper size setting
of the driver.