Canon iPF8400S Service Manual page 293

Code
Panel display
(last 4 digits)
(Large LCD)
2905 Mail box full.
Delete unwanted data
on your computer
to resume printing.
Press Stop
to cancel printing.
The mail box
is full.
Delete unwanted data
from your computer
to continue.
2906 Mail box full.
Cannot save. Delete
unwanted data on
your computer to
resume printing.
Press Stop to cancel
printing.
Too many jobs for
mail box.
Delete unwanted data
from your computer
to continue.
2907 Mail box full.
Delete unwanted data
Maximum jobs
stored. Delete
unwanted data.
2908 Hard disk error.
Press OK to reformat
Hard disk error.
Press OK to format
HDD and restart the
printer (Takes 40
min). This deletes
all HDD data.
(cannot be canceled)
Hard disk error.
Will format HDD and
restart the printer
(Takes 40 min). This
deletes all HDD data
(cannot be canceled)
2909 File read error.
Turn off printer,
wait a while, and
turn it on again.
Invalid files
will be deleted.
290A Hardware error.
03130031-290A
Turn off printer,
wait, then
turn on again.
2918
291A Roll sensor
cannot detect.
Turn on printer
again.
291B Hardware error.
03130031-291B
Turn off printer,
wait, then
turn on again.
291D Hardware error.
03130031-291D
Turn off printer,
wait, then
turn on again.
Panel display
Explanation/Detection sequence
(Small LCD)
A job save has been executed when the
available size of the permanent area of the
hard disk space was lost.
Cancel the job.
The 101st job has been received when 100
jobs are already saved in the permanent
area of the hard disk space.
100 jobs are already saved in the
permanent area of the hard disk space
(Warning).
HDD format error
HDD file error
HDD not connected.
HDD was not detected at startup.
Power On Cassette detection sensor detection failure
Again (cassette presence/absence sensor)
Cassette Sensor No cassette has been detected during
Detection Error cassette pickup.
Power On Roll sensor detection failure
Again Could not detect the roll unit.
Roll Sensor
Detection Error
Power On Lift shift timeout
Again A lift operation has been executed, but no
Lift Motion sensor has been detected or a sensor has
Timeout remained detected.
Power On Spur cam sensor detection failure
Again
Hardware Err 1
03130031-291D
Chapter 8
Remedial Action
Reorganize data.
Reorganize data.
Reorganize data.
1. Format as instructed by the on-panel
message.
2. Replace the HDD.
Restart the printer.
(The file in error is deleted, but the
printer will recover normally when it is
restarted.)
Connect the HDD/ Check the harness.
Replace the HDD.
1. Check to see if the cassette itself is
properly loaded.
2. Check and replace the sensor (I/O
mode).
1. Check the roll unit, and remove,
install or replace the roll unit.
2. Check I/O mode (roll unit
detection).
1. Switch off the printer, then back on.
2. The carriage cannot travel to the lift
drive position.
3. The lift drive cam is not engaged.
4. Faulty lift drive sensor
5. Faulty lift drive motor
Check the spur cam sensor in I/O
mode.
-If OK, check the lifter drive system.
-If NG, replace the sensor.
8-17