Canon iPF8400S Service Manual page 283

Code
Panel display
(last 4 digits)
(Large LCD)
200F This paper
cannot be used.
Check supported
paper sizes.
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change Paper
2010 Paper loaded askew.
Press Load/Eject
and reload the
paper.
Paper loaded askew.
Reload the paper.
Paper loaded askew.
Lift the
release lever.
Paper loaded askew.
Lift the release
lever and reload
the paper.
Paper loaded askew.
Press OK and
reload the paper.
Paper loaded askew
Lift the release lever.
2015 Cannot cut paper.
Press Load/Eject
and reload the
paper.
Cannot cut paper.
Reload the paper.
Cannot cut paper.
Lift the release
lever and reload
the paper.
Paper cutting
failed. Lift the
release lever.
2016 No sheets.
Press Load/Eject
and reload the
paper.
No sheets.
Lift the release
lever and reload the sheets.
The paper is too
small.
Check paper size.
Sheet removed.
Lift the release
lever.
Paper jam.
Press Load/Eject and reload
the
paper.
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
Cannot feed paper
Lift the release
lever and reload paper.
Cannot feed paper.
Reload the paper.
Cannot feed paper.
Press Load/Eject
and reload the
paper.
Panel display
Explanation/Detection sequence
(Small LCD)
Paper Size Paper mismatch (size)
Please Check Paper is too large
Paper Too Large -The width and length of paper detected are
longer than the supported size (1.5%
margin).
Paper Too Large
-Cannot detect the leading edge of paper
Please Check
even when the paper has been fed by 1300
Press Online Key
mm for roll paper and by the size
and Reload
mentioned above for cut sheet.
-Cannot detect the width of paper even
when the paper is fed by the size mentioned
above.
Paper Askew Skew (skewed right)
Please Reload
Paper Skew Paper is determined skewed as its edge is
read by the multisensor.
Paper Loaded
Crooked
Press Online Key
and Reload
Paper loaded
askew.
Remove paper
<When small LCD 1> Cutting failure/jam detected due to a
Cutting Error cutting failure
Please Cut Papr An idle cutter unit or a cutter blade that is
too blunt to cut sheet has been detected by
<When small LCD 2> the paper leading edge detection sequence.
Press (upper arrow) Key
to Release Paper
Sheets Paper loosened out of position while
Please Load printing
Sheet Not Loaded The trailing edge of paper has been
detected at least 20 mm shorter than the
length of cut forms detected.
Paper Jam Jam while picking up, ejecting or printing
Press (upper arrow) Key on paper
(A sequence of removing jams with the
pinch roller released is required)
Virtually all recovery errors that could
Paper Jam
occur in connection with paper pickup are
Press (upper arrow) Key
handled.
Paper Eject Err
Remove Paper
Chapter 8
Remedial Action
1. Check paper conditions (soiling,
tear-offs, residual paper chips, residual
trimming cuts, folds)/size.
2. Has the paper been fed successfully
(without slippage under a load or any
influence)?
3. Has the LF adjustment value set
correctly?
4. Hasn't the loaded paper shrunk to
below its margin in the particular
environment?
Reload the paper.
Reload the paper.
1. Open and close the release lever to
reload the paper.
2. Remove the paper once and then
refeed it.
8-7