SCOOP EXL Stretcher
4.1 Adjusting the length
The length of the SCOOP EXL stretcher is adjustable
(4 positions). This adjustment allows the stretcher to be
adapted to the height of the patient.
When preparing the stretcher, adjust its length so that it is
properly adapted to the height of the patient.
ADJUSTING THE LENGTH
To adjust the stretcher length, proceed as follows:
1. Release the locking levers on both sides of the stretcher, positioning them facing upwards (Figure 2).
2. Pull out the foot section to the desired length. The stretcher can be locked in 4 different lengths, corresponding with the holes
in the tubular part of the foot section (Figure 3A, 3B, 3C, 3D). While adjusting the length it is recommended to keep the two
parts that make up the stretcher attached.
Figure 3A - Position 1
Figure 3C - Position 3
© Ferno Washington Italia ScoopExl - Rel.161115 - ENG
4 - STRETCHER CONFIGURATION
Figure 2 - Locking handles facing up: STRETCHER
Figure 1 - Length adjustment system
UNLOCKED
Stretcher configuration
Locking
handles
Figure 3B - Position 2
Figure 3D - Position 4
9