Control Panel; Control Mode; Dmx Addressing - SHOWTEC Moving Par 64 User Manual

Control Panel

When the indicator light is on, means the Moving Par is working
A. Display
B. Audio Sensitivity Adjustment
C. [EXIT] Button

Control Mode

The fixtures are individually addressed
The fixtures respond to the DMX signal from the controller. (When you select the DMX address and save it, the
controller will display the saved DMX address the next time.)

DMX Addressing

The control panel on the front side of the base allows you to assign the DMX fixture address, which is the first
channel from which the Moving Par will respond to the controller.
Please note when you use the controller, the unit has 6 channels.
When using multiple Moving Pars, make sure you set the DMX addresses right.
Therefore, the DMX address of the first Moving Par should be 1(A001); the DMX address of the second
Moving Par should be 1+6=7 (A007); the DMX address of the third Moving Par should be 7+6=13 (A013), etc.
Please, be sure that you don't have any overlapping channels in order to control each Moving Par
correctly.
If two or more Moving Pars are addressed similarly, they will work similarly.
For address settings, please refer to the instructions under "Addressing' (menu
Controlling:
After having addressed all Moving Par fixtures, you may now start operating these via your lighting controller.
Note: After switching on, the Moving Par will automatically detect whether DMX 512 data is received or not.
If there is no data received at the DMX-input, the "LED " on the control panel will not flash.
The problem may be:
- The XLR cable from the controller is not connected with the input of the Moving Par.
- The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It's necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure proper
transmission on the DMX data link.
A B C
D. Down Button
E. Up Button
F. [M/ENTER] Button
D E F
on a data-link and connected to the controller.
11
Fig. 6
)