Installation; Installing The Lamp - SHOWTEC Moving Par 64 User Manual

Installation

Installing the Lamp

The Showtec Moving Par 64 uses the Par 64 (ordercode 82183 / 82184 / 82185) bulb as manufactured by all
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
• Always read the safety instructions that are included with the lamp.
• Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean,
lint-free towel and rubbing alcohol.).
• Always read all the safety warnings at the beginning of this manual, before replacing the lamp !!!
1. Loosen the 2 springs on the back of the head and gently open the back cover.
2. Gently press the large safety spring together and remove the spring.
3. Read lamp instructions. Do not touch the lamp bulb glass.
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.). Put large safety spring back to fasten the PAR 64 bulb.
4. Insert the lamp pins into the small holes in the lamp socket.
5. Close the housing and fasten the 2 springs.
1 2
8
4
Fig. 4