Operator - KEB combivert R6-S Instruction Manual

Installation and Connection
4.6

Operator

As an accessory, a keypad operator can be installed. A digital operator (00.F5.060-1000) is provided with every
regen unit. To prevent malfunctions, the COMBIVERT must be brought into nOP status before connecting or
disconnecting the operator (de-activate the enable input). When starting the COMBIVERT R6, it is started with the
last stored values or factory settings regardless of whether the operator is installed or not.
i
Do not place KEB F5 Elevator Drive Keypad on R6, it is not compatible and will display E.CArd.
X6C
5 4 3 2 1
9 8 7 6
RS 232 cable
Part number
00.58.025-001D
Length 3 m
US - 26
Digital operator (part number 00.F5.060-1100)
Serial Interface operator (part number 00.F5.060-2000)
x x 5-digit LED Display
x x Operating-/Error display
Normal "LED on"
Error "LED blinks"
- x Interface control
Transmit "LED on"
x x Double function keyboard
- x X6B HSP5 programming and diagnostic
interface
- x X6C RS232/RS485
Do not connect a PC to the operator interface connector on the COMBIVERT R6
unit! Damage to the PC may result. Direct connection, PC to the COMBIVERT R6
is only possible with a special cable HSP5 cable (part number 00.F5.0C0-0010) or
USB Converter Cable (part number 00.58.060-0020)
PIN RS485 Signal
1 - -
2 - TxD
3 - RxD
4 A' RxD-A
5 B' RxD-B
6 - VP
7 C/C' DGND
8 A TxD-A
9 B TxD-B
9-pole Sub-D socket
PC
Housing (GND)
Meaning
reserved
Transmission signal RS232
Receive signal RS232
Receive signal A RS485
Receive signal B RS485
Voltage supply +5 V (Imax=10 mA)
Data reference potential
Transmission signal A RS485
Transmission signal B RS485
9-pole SUB-D connector
START
ENTER FUNC.
F/R SPEED
STOP
X6B
C O M B I V E R T
X6C X6D
Operator X6C