Canon EOS C200 Instruction Manual page 94

Setting the Time Code
About the Time Code Display
An icon may appear next to the time code depending on the operation. Refer to the following table.
Icon
R The time code mode is set to [Regen.].
94
P The time code mode is set to [Preset] and the running mode is set to [Rec Run].
F The time code mode is set to [Preset] and the running mode is set to [Free Run].
H Time code display is on hold.
No icon Time code during clip playback.
NOTES NOTES
• The frames value of the time code runs from 0 to 23 (frame rate set to 23.98P or 24.00P), from 0 to 24 (frame
rate set to 25.00P or 50.00P), or from 0 to 29 (all other frame rates).
• When you are using interval recording, frame recording or slow motion recording, you cannot select the [Free
Run] running mode. Conversely, when you are using pre-recording mode, [Free Run] is set automatically and
cannot be changed.
• When you are using interval recording, frame recording or slow motion recording, the time code signal will not
be output from the SDI terminal or HDMI OUT terminal.
• When you mix drop frame and non-drop frame time codes, there might be a discontinuity in the time code at
the point where the recording starts.
• When you are using the [Free Run] running mode, the time code will continue running as long as the lithium
button battery has some charge left, even if you disconnect all other power sources.
• If you set an assignable button to [Time Code] (A 119), you can press the button to open the
[B # System Setup] menu.
Description