Table of Contents
Advertisement
Selecting the Output Signal in
When the camera is in
terminal.
Operating modes:
1 Open the [HDMI Max Res.] submenu.
> [B " System Setup] > [HDMI Max Res.]
2 Select [3840x2160] or [1920x1080] and then press the joystick.
NOTES
• The HDMI OUT terminal is for output only. Do not connect the camera to another device's output terminal
using the HDMI OUT terminal as this will cause a malfunction.
• Correct operation cannot be guaranteed when connecting the camera to DVI monitors.
• Video may not be output correctly depending on the monitor. In such case, use another terminal.
• You can set both
[On] to use the camera's REC button to control also the recording operation of an external recorder connected
to the HDMI OUT terminal. The camera's time code signal will be output as well.
• The time code will not be output from the HDMI OUT terminal in the following cases.
- During
mode.
- During SD output.
- During slow motion recording.
- During interval recording.
- During frame recording.
HDR Output
When you record RAW clips, the camera can output high dynamic range (HDR) video compliant with the ITU-R
BT.2100(PQ) standard from the SDI terminal or HDMI OUT terminal. The signal output will use narrow range
coding.
Operating modes:
1 Open the [HDR/LUT] screen.
> [
! Custom Picture/HDR] > [HDR/LUT]
2 Select [HDR: Off] and then press the joystick.
3 Push the joystick left/right to select [HDR: PQ] and then press the joystick.
• Select [HDR: Off] to turn off HDR output.
Mode
mode, you can select the maximum resolution output from the HDMI OUT
> [3 $ Recording/Media Setup] > [Rec Command] and [HDMI Time Code] to
Connecting to an External Monitor or Recorder
143
Advertisement
Table of Contents
