Selecting Drop Or Non-Drop Frame; Putting The Time Code Display On Hold - Canon EOS C200 Instruction Manual

Digital cinema camera
Hide thumbs Also See for EOS C200:
Table of Contents

Advertisement

Setting the Time Code's Initial Value
If you set the time code mode to [Preset], you can set the initial value of the time code.
1 Open the [Set Time Code] submenu.
> [B # System Setup] > [Set Time Code]
2 Select [Change] and then press the joystick.
• The time code setting screen appears with an orange selection frame indicating the hours.
• To reset the time code to [00:00:00.00], select [Reset] instead. If the running mode is set to [Free Run], the
time code will be reset the moment you press the joystick and keep running continuously from 00:00:00.00.
3 Push the joystick up/down to set the hours and press the joystick to move to the minutes.
• Change the rest of the fields (minutes, seconds, frame) in the same way.
• Press the CANCEL button to close the screen without setting the time code.
4 Select [Set] and press the joystick to close the screen.
• If the running mode is set to [Free Run], the time code will start running from the selected time code the
moment you press the joystick.

Selecting Drop or Non-Drop Frame

When the frame rate is set to 59.94P or 29.97P, you can select between a drop frame (DF) or non-drop frame
(NDF) time code, depending on how you plan to use your recordings.
With all other frame rates, the time code is set to non-drop frame (NDF) and cannot be changed.
Operating modes:
1 Open the [Time Code DF/NDF] submenu.
> [B # System Setup] > [Time Code DF/NDF]
2 Select [DF] or [NDF] and then press the joystick.
• The time code display will differ depending on the setting. When you select [DF], the time code will appear
as [00:00:00.00]; when you select [NDF], it will appear as [00:00:00:00].

Putting the Time Code Display on Hold

If you set an assignable button to [Time Code Hold] (A 119), you can press the button to freeze the display of
the time code*. While the time code display is put on hold, [H] will appear on the screen next to the time code.
Operating modes:
The time code continues to run normally while the time code display is on hold. When you resume the time code
display, the current time code will be displayed.
* The time code signal output from the terminals will not be put on hold. However, the time code displayed on a monitor connected
to the HDMI OUT terminal will be put on hold.
Setting the Time Code
93

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eos c200b

Table of Contents