Aeronaut Pilot Manual page 12

Glue the seat squab 118 to the front section 119 and the
bottom section 117. Bend the side panel 120 inwards slightly
along the engraved lines. Fit the seat squabs in the side
panels. Insert the backrest 121 and the backrest side fairings
122. Add the second side panel, and glue all the parts
together.
Cut the seat column 126 to a length of 35 mm. Fit the
footrest 125 on the column, and glue the parts together. Fit
the plate 124 on the pillar, and glue it in place 25 mm below
the seat bottom.
Paint the seat, and insert it in the hole in the forward
deckhouse floor.
Assemble the four rear seats in the same manner as the
front seat.
Insert the seat pillars in the holes, set them to a height of 13
mm above the floor, and glue them in place.
Glue together parts 135, 137, 138 and 139 to form the two
rear tables, then glue them in the slots in the floor.
Glue the front tables to the wheelhouse frame and the
partition and side walls.
Don't glue them to the floor!
Fig. 25
Cable openings
Fig. 22
122
Fig. 23
129
134
Fig. 24
138
135
Rear tables
123
121
120
130
139 140
137
137
136
Front tables
118
119
117
125
124
126
133
131
132
128
127
138